Samsung AC071MN4PKH Installation Manual - page 24
24
Installation Procedure
Ins
tallation Pr
oc
edur
e
English
3 Check whether the option values that you have set are
correct by pressing the
(Mode) button repeatedly
[SEG2, SEG3]
[SEG11, SEG12]
[SEG21, SEG22]
[SEG4, SEG5]
[SEG14, SEG15]
[SEG23, SEG24]
[SEG6, SEG8]
[SEG16, SEG17]
[SEG9, SEG10]
[SEG18, SEG20]
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor
on the indoor unit and then press the
(Power)
button on the remote control twice. Make sure that
this command is received by the indoor unit. When it
is successfully received, you can hear a short sound
from the indoor unit. If the command is not received,
press the
(Power) button again.
5 Check whether the air conditioner operates in
accordance with the option values you have set:
a Reset the indoor or outdoor unit.
ŷ Indoor unit : Press the
(Set) and
(Option)
buttons on the remote control simultaneously for
4 seconds.
ŷ Outdoor unit : Press the K3 button.
b Remove the batteries from the remote control,
insert them again, and then press the
(Power)
button on the remote control.
MR-EC00 and MR-EH00 remote controls
Low Temp button
High Temp button
Mode button
Low Fan button
High Fan button
Setting the
option values
Entering the
mode for setting
the options
NOTE
ŷ The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the
(High Temp) and
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
Steps
Remote control display
b Set the SEG24 value by rotating the Wheel clockwise
until the value you want to set appears on the remote
control display.
SEG24
When you rotate the Wheel, values appear in the following order: