Samsung AC071MN4PKH Installation Manual - page 29

29

Ins

tallation Pr

oc

edur

e

English

Steps

Remote control display

b  Set the SEG22 value by pressing the 

 (High Fan) button repeatedly until the 

value you want to set appears on the remote control display.

When you press the 

 (Low Fan) or 

 (High Fan) button, values appear in the 

following order: 

SEG22

18 Press the

(Mode) button. Heat and Off appear on the remote control display. 

19 Set the SEG23 and SEG24 values:

a  Set the SEG23 value by pressing the 

 (Low Fan) button repeatedly until the 

value you want to set appears on the remote control display.

SEG23

b  Set the SEG24 value by pressing the 

 (High Fan) button repeatedly until the 

value you want to set appears on the remote control display.

When you press the 

 (Low Fan) or 

 (High Fan) button, values appear in the 

following order: 

SEG24

3  Check whether the option values that you have set are 

correct by pressing the 

 (Mode) button repeatedly

[SEG2, SEG3]

[SEG11, SEG12]

[SEG21, SEG22]

[SEG4, SEG5]

[SEG14, SEG15]

[SEG23, SEG24]

[SEG6, SEG8]

[SEG16, SEG17]

[SEG9, SEG10]

[SEG18, SEG20]

4  Save the option values into the indoor unit:

Point the remote control to the remote control sensor 

on the indoor unit and then press the 

 (Power) 

button on the remote control twice. Make sure that 

this command is received by the indoor unit. When it 

is successfully received, you can hear a short sound 

from the indoor unit. If the command is not received, 

press the 

 (Power) button again.

5  Check whether the air conditioner operates in 

accordance with the option values you have set:

a  Reset the indoor or outdoor unit.

ŷ Indoor unit : Press the 

 (Set) and 

(Low Fan) buttons on the remote control 

simultaneously for 4 seconds.

ŷ Outdoor unit : Press the K3 button.

b  Remove the batteries from the remote control, 

insert them again, and then press the 

 (Power) 

button on the remote control.