Sensear SM1P Manual - Operating The Headset
DOC00078 SM1P Manual rev 01.3
10
En
glis
h
OPERATING THE HEADSET
POWER ON:
1.
Press and release the “Power” button shown in Figure 1.
2. All the LEDs will turn on briefly, & an audible sound will be heard
through the headset.
3. The Green LED will flash at a normal rate as described below.
POWER OFF:
1.
Press and hold the “Power” button for 2 seconds.
2. All the LEDs will turn on briefly and an audible sound will be
heard through the headset as the headset powers off.
MODE:
When the headset is powered up, the unit is set into ‘
mode’**. By pressing the power button, this toggles ‘
mode’.
‘
mode’ allows full situational awareness of your surroundings
in addition to two-way radio communications.
The power button toggles between Quiet mode
and
mode
The volume control buttons can be used to raise or lower
the audio level of the
mode.
**The default mode on power up can be programmed
using the Sensear app.
QUIET MODE:
By pressing the power button, this toggles
‘Quiet mode’. Quiet
mode only allows two-way radio communications to pass through
the headset.
mode
Green LED, blink twice every 4 seconds