Sensidyne gilian gilibrator 2 Operation & Service Manual - Warnings !
7
GILIAN GILIBRATOR 2 CALIBRATION SYSTEM
Sensidyne Document No. 850190M (Rev G)
READ AND UNDERSTAND ALL WARNINGS BEFORE USE
IMPORTANT COMPATIBILITY NOTE
Most flow cells designed for the original Gilibrator base are compatible with the Gilibrator 2 base unit. If your existing flow
cell is not compatible with the Gilibrator 2 base, the unit will display a false SAMPLE# reading immediately after start-up. If
this happens, your flow cell needs to be returned to Sensidyne to be upgraded. See Appendix C for more information.
Read and understand
ALL
warnings before using this product. Failure to read, understand, and comply with
ALL
warnings could result in property damage, severe personal injury, or death.
Read and understand
ALL
applicable Federal, State, and Local environmental health and safety laws and
regulations, including OSHA. Ensure complete compliance with
ALL
applicable laws and regulations before
and during use of this product.
UNDER NO CIRCUMSTANCES
should this product be used except by qualified, trained, technically
competent personnel and not until the warnings,
Operation and Service Manual
, labels, and other literature
accompanying this product have been read and understood.
The
Operation and Service Manual must be read and understood by each user before operating this product
or using its accessories, in order to ensure proper and safe use and installation of this product and to ensure
familiarity with the proper treatment and safety procedures in the event of an accident.
DO NOT
remove, cover, or alter any label or tag on this product, its accessories, or related products.
DO NOT
operate this product should it malfunction or require repair. Operation of a malfunctioning
product, or a product requiring repair may result in serious personal injury or death.
DO NOT
attempt to
repair or modify the instrument, except as specified in the
Operation and Service Manual
. If repair is needed,
contact the Sensidyne Service Department to arrange for a Returned Material Authorization (RMA).
Use
ONLY
genuine SENSIDYNE
®
replacement parts when performing any maintenance procedures
described in this manual.
Failure to do so may seriously impair instrument performance
. Repair or alteration
of the product beyond the scope of these maintenance instructions, or by anyone other than an authorized
SENSIDYNE
®
serviceman, could cause the product to fail to perform as designed and persons who rely on
this product for their safety could sustain severe personal injury or death.
ALWAYS
turn off the instrument before changing any batteries.
ONLY
use Soap Solution Part No. 800450 with the a Wet Flow Cell Assembly. Use of other soap solutions
can damage the Flow Cell.
Piston Cell Warning
: Do not close the bleeder valve on the piston cell assembly until the green ready
light (LED) lights up.
WARNINGS !
IMPORTANT NOTE
(effective 7/1/99)
CE approved Control Unit Bases have 9-Pin cables and CANNOT be used with Piston Cells.
Non-CE Control Unit Bases have 15-Pin cables and can be used with Piston Cells.