Sentrol ZX400 Manual - page 15
15
Programming Account Code and
Telephone Number Digits
When the location being programmed is an account
code or telephone number digit (see Installer Level
Programming - Communication Telephone Numbers
Description and Area Event Reporting Description),
the value will be displayed as an “H” followed by a
single digit. The “H” indicates that this location is a
Hexadecimal field. The valid entries for these loca-
tions are “0” through “F”, where A - F correspond
to 10 - 15 respectively.
To program a digit, enter digits as normal. To enter
an A - F, enter a ‘1’ followed by a ‘0’ through ‘5’.
As in programming normal fields, if too many digits
are entered, the first digit entered will be discarded.
The ENTER, OFF CANCEL, ‘C’, and CLEAR keys will
work the same as described above.
Programming Report Codes and Attribute
Fields
When the location being programmed is a report
code (see Installer Level Programming - Zone Re-
port Codes Description thru System Report Codes
Description) or an attribute field (see Installer Level
Programming - Area Data Descriptions thru Zone
Data Descriptions and System Report Codes Descrip-
tion thru Area Schedules Description), the value will
be displayed as an “H” followed by two digits. The
“H” indicates that this location is a Hexadecimal field.
The valid entries for these locations are “00” through
“FF”, where A - F correspond with 10 - 15 respec-
tively. The Control Station display will automatically
display the hexadecimal value.
To program one of these locations, enter digits as
normal. To display a ‘1’ in the first digit location,
you must enter a ‘0’ before the ‘1’, i.e. ‘01’ displays
a ‘1’. To enter an A - F, enter a ‘1’ followed by a ‘0’
through ‘5’. For example:
Enter
To Get
1-2-3
C3
0-1-2
12
1-8
18
0-1-1-0
1A
1-2
0C
2-1
21
INSTALLER LEVEL PROGRAMMING
As in programming normal fields, if too many digits
are entered, the first digit entered will be discarded.
The ENTER, OFF CANCEL, ‘C’, and CLEAR keys will
work the same as described above.
Additional Programming Notes
To exit out of Edit Function Map mode and return
the Control Station to the idle state, press the CLEAR
key from the LOCATION prompt. (You may need to
press the CLEAR key several times to get to the LO-
CATION prompt). An “End Local Programming”
event will not be logged until 255 seconds after you
exit programming mode. This is to allow you to
exit and re-enter programming mode repeatedly
without logging each one. To force an “End Local
Programming” event to be logged, immediately (i.e.:
to have it reported to the Central Station), press and
hold the CLEAR key for three seconds.
When programming the value at the last program-
ming location, the Control Station will return to the
LOCATION prompt if the ENTER key is pressed.
If the panel has been programmed from RPM/2 Pro
and the Agency Code has been loaded into the panel,
then the locations corresponding to the telephone
numbers and account codes will not be editable.
Programming Zone Names
Only the LCD and VFD Control Station may be used
to program zone names. Press the ‘9’ key and enter
the installer passcode to enter programming mode.
Press the ‘4’ key to program the zone names. The
Control Station will prompt you for a Zone ID to be
programmed. The valid Zone IDs are 1 to 30.
Enter a number corresponding to the Zone ID and
press ENTER. Once a valid Zone ID is selected, the
control will display the Zone ID and the current Zone
Name with the cursor on the first character. Press
the key associated with each character. Each keypress
will change the display to the next character listed
for that key. The characters available for program-
ming the Zone Names are located on the next page.