Serene Central Alert CA-CX User Manual - page 10
it will exit the Learn mode.
4. Press and hold the test button on the accessory
CA-AX (audio sensor) for more than 10 seconds
until CA-PX flashes, vibrates, and beeps (if
speaker is On) twice.This confirms the learning.
5. Repeat the steps 3 and 4 with the CA-DXH
accessory.
6. Press the Reset button on the CA-PX to exit the
learning mode at any time.
7. Test the system - Press the Test button on each
accessory one at a time. Verify that the
corresponding icon button on the CA-PX is
activated. The CA-PX will flash, vibrate and beep
(if speaker is On) for about 45 seconds. Press
Reset to stop at any time.
8. Repeat the test with the CA-DXH. Press Reset to
stop at any time.
9. Repeat the steps above to learn (or register) and
test more accessories as desired.
2. Learning CA-PX into a CA-360 System
Example Application
This is a typical application for adding a CA-PX to a
CA-360 system, in order to improve mobility freedom
and coverage area.
Each CA-PX must be learned (or registered) to the
CA-360 system before before it can be recognized
(Up to 10 CA-PX may be added to one CA-360 master
unit).
Note: All previously learned accessories in the
CA-PX will be lost during this process, and all lost
accessories must be learned again through the
CA-360 master unit.
10