Serene Central Alert CA-CX User Manual - page 13
Alert Signals Acknowledge
Upon receiving a wireless notification signal from any
accessory:
1. The unit activates a unique motor vibration,
blinking icon button, flasher and sound
(if speaker is On).
2. After reviewing the blinking icon button, the user
can then press the Reset button to acknowledge
and stop all alert outputs. The blinking icon button
continues to stay lit for 5 more seconds.
3. For a deaf/blind user who cannot visualize the
blinking icon button, the user will need to press
each icon button sequentially to determine the
activated icon button. When the correct icon button
is pressed, the vibration will become continuous –
indicating this is the correct one. The user can then
press the Reset button to acknowledge, and stop
all alert outputs. (Note: Each button is embossed
with a Braille character).
Recall Last Activated Alert
The last activated alert may be recalled for review
purposes.
1. Press and hold the Reset button for 2 seconds
and it will recall the last activated alert. Unique
vibration, blinking icon button and speaker sound
will be repeated for 45 seconds. (Note: The flasher
will not flash during recall).
2. A deaf / blind user can press each icon button
sequentially to determine which icon button is
active. When the user presses the correct icon
button, the vibration will become continuous –
indicating this is the correct one. Each button is
embossed with Braille.
3. Press the Reset button to stop and exit the mode.
13