Servonaut Zwo4 HS12 User Manual - page 11
Quick Start
11
Ÿ Press [Change] and choose [x5 Servo]
in the channel menu.
Ÿ By pressing [Test] you can switch to the
operating screen to test if the fifth wheel
plate lock works. Press one of the menu
buttons to get back to the control menu.
Ÿ Press [OK] a few times to get back to
the operating screen.
Ÿ You can adjust the direction of the servo
rotation and the endpoint with [Menu] >
[Servo] > [x5 Servo]. Save a name for
the channel e.g. fifth wheel.
Ÿ Press [Menu] > [Control] and then the
key of the softkey pair you want to use
to get to the control menu. Here you can
assign a name separately for the left
and right key e.g. Open and Close.
Choose light set (optional)
If you have a standard light set in your
model you can choose a template in the
next step with [Light set]. See chapter Light
Sets for details
With [OK] back to the main menu.
Bind the receiver
Follow the instructions of the receiver
manual and put it in bind mode. Then press
[Receiver] and [Bind] on the radio. The
receiver flashes green. Follow the receiver
manual.
Set up special functions
If you want to set special functions for the
softkeys and channels 5 to 12 you have to
assign the servo channels to the controls.
Example:
Fifth wheel plate lock on channel 5
Ÿ Press [Menu] > [Control] and then a key
of the softkey pair you want to use e.g.
upper right.
Ÿ Press [Type] and choose the channel
type [Switch - +].
Ÿ To assign a channel to a control go to
the second menu page with the blue
button [1v4].
Charging the battery
Your Zwo4 radio has a NiMH battery with 4
cells and 4,8 V. There are two ways to
charge it: a quick charge and a normal
charge.
Ÿ Quick charge: Adjust your battery
charger to NiMH and the charging
current to 0,5 or 1A. It takes 2 to 5
hours to charge. Do not leave the radio
unattended.
Ÿ Normal charge: We recommend a
charging current of 200 mA for normal
charge. It takes 14 hours. If the radio
stays connected to the charger longer it
is not dangerous.
Caution: You need a special type of
charger.
New model
Go to the model menu with
[Menu] > [Model] > [New model].
Choose the template MC19 or F14
depending on your favorite layout for the
joysticks. See chapter Menu Model -
Channel Assignment
Set a name for your model. If you don’t
choose one the radio shows „Modell“ and
the model number instead.
3. Quick Start: The First Steps