Servonaut Zwo4 HS12 User Manual - 8. Light Sets
Light Sets
17
Caution: If you select a light set
template all adjustments you made
for the light controls and mixers before are
reset.
Light set with multiswitch function
Some of the common light sets need an
additional multiswitch or nautic module in
the radio. With the Servonaut HS12 there is
no need for upgrading - the necessary
channel addition is already built-in. The
radio supports Robbe/Futaba as well as
Graupner/JR - choose the servo channel 7
or 8. Connect the light set to one of these
channels. With the green menu button
[Menu] > [Multiswitch] you get to the adjust-
ment menu. See chapter Menu Multiswitch.
For a quick start there is a list of common
light sets with presets at [Menu] > [Model] >
[Light set]. The light sets use the servo
channel 8 for the multiswitch - you may need
to replug the channel 8 in the receiver. In the
radio you can’t switch channels 7 and 8 if
one of them has multiswitch function.
Light set without
multiswitch function
Some light sets aren’t controlled via multi-
switch channels but one or two normal servo
channels. Connect the light set to the chan-
nels you want, normally channels 5 to 12.
For a quick start there is a list of common
light sets with presets at [Menu] > [Model] >
[Light set]. Choose EN for the english
presets.
Servonaut mini light sets
For mini multiswitches and mini light sets
from Servonaut you can choose between
three options:
1. Control with joysticks (standard)
Ÿ Press [Menu] > [Control] and move one
joystick. With [Reset] you can delete all
old adjustments. With [Reverse] you can
swap the joystick direction if necessary.
Ÿ To assign a channel to the control press
the blue button to get to page [2v4].
Ÿ Press [Change] and choose the receiver
channel that mini multiswitch or light set
are connected to. Leave all other adjust-
ments for control and servo channel as
they are.
Ÿ We recommend assigning a [Name] to
the channel e.g. ML4. You can also
name the servo channel in the servo
channel menu for an even better over-
view.
Ÿ Press [OK] a few times to get back to
the operating screen.
2. Control with one softkey pair
Ÿ Press [Menu] > [Control] and press one
key of the pair you want to use.
Ÿ With [Reset] you can delete all settings
for this control. Switch the softkeys with
[Reverse] if necessary.
Ÿ To assign a channel to the control go to
page [2v4] with the blue menu button.
Ÿ Press [Change] and choose the receiver
channel connected to the mini multi-
switch or mini light set. Don’t change
any other settings for the control and
servo channel.
Ÿ We recommend assigning a [Name] for
each softkey, e.g. Indicator L and Indi-
cator R. You can also name the channel
in the servo channel menu, e.g. ML4 for
the light set, for an even better overview.
Ÿ Press [OK] a few times to get back to
the operating screen.
3. Control with two softkey pairs for the
Servonaut ML4
Ÿ Indicator: Press [Menu] > [Control] and
press one key of the pair you want to
use for the indicator. With [Reset] you
can delete all settings for this control.
8. Light Sets
Special functions