Smarthome 4071 User Manual - page 11
ControLinc
™
Maxi
™
User’s Guide
Programming Individual Buttons
The 5 User Defined On/Off Button Pairs can be split and individually programmed to allow each of the 10
buttons to be programmed independently (not as pairs). This allows for easy control of up to 10 different
addresses. The individual buttons can be programmed to control an address or to send a string of X10
commands. Additionally the “USER DEFINED” Button (available when the cover is open) can be
programmed to send a string, or “sequence” of X10 commands giving the user 11 total programmable
buttons.
To program an individual button, follow these steps:
1. Open
the
cover
2. Press and hold the Program ControLinc button for 3 seconds. The ControLinc Maxi sounder will
activate and the Status LED will begin to blink.
3. Close the cover (or, if programming the User Sequence Button, press the User Sequence Button)
4. With the cover closed, press a user programmable button (any of the 10 On/Off Button Pairs)
5. Open
the
cover
6. Press a Unit Code Button (1 through 5) for the function to be programmed (see below):
Functions:
#1 – Toggle Mode for Appliances
When the button is pressed once, an On Command will be sent for the address programmed.
When pressed again, an Off command will be sent.
#2 – Toggle Mode for Lamps
Like Function 1; when the button is pressed once, an On Command will be sent for the
address programmed. When pressed again, an Off command will be sent. Pressing and
holding the button will send Bright or Dim commands until released.
#3 – Non-Toggle for Appliances
Always sends the same command (i.e. On or Off) for the programmed address
#4 – Non-Toggle for Lamps
Like Function #3; always sends the same command (i.e. On or Off) for the programmed
address. Pressing and holding the button will send Bright commands (if the On command is
programmed) or Dim commands (if the Off command is programmed).
#5 – X10 String/Sequence
Sends up to four X10 addresses and/or commands.
7. Enter the address and command:
Functions 1 and 2 Press a House Code (Buttons A through P)
Press a Unit Code (Buttons 1 through 16)
Functions 3 and 4 Press a House Code (Buttons A through P)
Press a Unit Code (Buttons 1 through 16)
Press the On or Off Button
Function 5
Enter up to four X10 Addresses (House Code and/or Unit Code) and/or
commands (On, Off, Bright, Dim, All Lights On, All Units Off)
8. Press the Program ControLinc Button to complete programming. The sounder will beep and the LED
will stop blinking, illuminating steady.
Page 11 of 20