SPX 3641 User Manual - Test Report
4
Battery Charger and Analyzer User Guide
7. Press a number key to select one of the following
methods of battery identification:
•
CCA or MCA:
1. Enter the CCA or MCA number with the number keys,
press GO.
2. Select
Yes/No if Gel Cell/AGM battery, testing will
begin immediately.
•
Amp Hours:
1. Enter the Amp hours with the number keys, press
GO.
2. Select
Yes/No if Gel Cell/AGM battery, testing will
begin immediately.
Figure: Bar Code/CCA/Amp hours
When the Battery Load test or the battery charge process
are active, the PROGRESS status light will glow. Respond
to any messages displayed during the Battery Test. One of
two results will be displayed at the completion of testing:
•
If the Battery Test detects a failure (Bad battery), the
BAD status light will glow.
•
When the test is completed (Good battery), the GOOD
status light will glow.
Test Report
The battery test results are saved into the battery charger
and analyzer memory to be printed if required.
To print the battery test report, follow these steps:
1. Press the MENU button. Press
Button 1 to select Test
Results.
2. Press
Button 1 to print the report.
6. Press a number key to respond to each of the three
battery visual inspection questions:
•
Case cracked?
Figure: Cracked case
•
Posts/Terminals broken?
Figure: Broken post
•
Battery frozen?
Figure: Frozen battery
Battery Service Checksheet
Unit ID=94-5
BATTERY CONDITION
Battery is bad
Warranty code: 15FAZ707
Store:_______________________________________
Invoice: