Spypoint LIVE User Manual - page 8
14
15
English
English
Time Lapse:
(Off/10min/30min/
1h/2h)
Allows the camera to take pictures at regular
preset intervals. This option may be useful to get
pictures of animals outside the detection range of
the camera.
When the option “Time Lapse” is enabled:
• The “Delay” option is disabled.
• The “Multi-shot” option is disabled.
• The picture size is reduced to 800x600 in local
recording on the memory card.
Note: The “Time Lapse” recording option only
applies in “PHOTO” mode, not in “VIDEO”
mode.
Time start/
Time stop:
Allows the user to set the period of operation of
the camera. The start and stop time are the hours
during which the camera is in action and can
record pictures or videos.
Example: if the user selects a start time “7:00
am” and a stop time “11:00 am”, the camera will
only detect for that period of time and will stay
inactive for the remaining hours. Press “OK”
and use “
UP
” or “
DOWN
” to adjust the hour.
Press “OK” again to set the minutes. When the
time is properly set, press “OK” again to go back
to other settings. For an activation of 24 hours,
the same start and stop time must be entered
(example: 00:00 as start time and 00:00 as stop
time. These hours are the default configuration of
your camera)
Note: The hours can be recorded over a 12 or 24
hours period. Refer to the “Time format” option
(00:00 means midnight)
Stamp:
(Yes/No)
Select or cancel imprinting date, time,
temperature and moon phases on photos.
New moon:
Waxing Crescent:
First Quarter:
Waxing Gibbous:
Full moon:
Waning Gibbous:
Last Quarter:
Waning crescent:
Temp.
format:
(°F/°C)
Changes the temperature display.
Language:
(English/Français/
Deutsch)
Sets the display language of the camera’s menus.
Theft alert:
(Yes/No)
In case of theft, enabling this option allows the
camera to switch into an alert state and to begin
sending pictures on the user's account starting
with the most recent ones.
Note: Photos are sent in “Large” format only.
Also, the user receives an alert message to
his email address or by an SMS message
to his cellphone (fees may apply for SMS
messages) giving information about when the
camera was moved for the last time (See “SMS
Configuration” for details).
To completely turn off the camera and bypass the
“Theft alert” option, press the “BACK” button
while sliding the switch to the “OFF” position.