Spypoint LIVE User Manual - page 9
16
17
English
English
Mode:
(Standalone/
Cellular/Security)
Sets the operating mode of the camera.
When “Standalone” mode is activated:
• The camera operates normally by recording
photos or videos locally on the memory card.
•
The options “Theft alert”, “Carrier”,
“Synchronize”, “Synchronize at” and
“Transmit format” are disabled since no
cellular communication is performed in this
mode.
• The presets of the “Time Lapse” option are
reduced to 15s/30s/1min/5min/10min/30min/1
h/2h. (See the option “Time Lapse”)
When “Cellular” mode is activated:
(A subscription to
mySPYPOINT
is required,
visit www.myspypoint.com for details)
•
The camera operates in cellular
transmission mode and communicates with
mySPYPOINT
server following the
presets of the options “Synchronize” and
“Synchronize at”.
• Videos cannot be sent to the
mySPYPOINT
user’s account.
• Photos are also stored locally on the memory
card.
Note: In Cellular mode, it is recommended to
use an external 12 volt input (BATT-12/KIT-
12V/AD-12V, sold separately) in order to get
best results and longer battery life (see “Power
Supply” for details).
When “Security” mode is activated, the
operation is the same as in “Cellular” mode,
except:
• The camera makes a self check every minute
to verify if images have been taken. If so, the
camera will transmit to the
mySPYPOINT
user’s account.
•
The camera still communicates with
mySPYPOINT
server following the presets
of the options “Synchronize” and “Synchronize
at”.
• The “Multi-shot” speed is improved with a 5
seconds delay between each take.
• If the option “Multi-shot” is enabled, the
transmission is performed once the serie of
photos is recorded.
• The option
“Security Alert” is available on the
mySPYPOINT
user’s account. This option
can be activated via
mySPYPOINT
only
(see "SMS Configuration" for details).
Note: Security mode is recommended for use
in areas where detections are rare and where the
camera can't be powered of a main electricity
supply. It is a good compromise between security
and battery life.
Country
Allows the user to choose the country in which
the camera is used. This option displays the list
of the corresponding cellular providers.
Carrier:
This setting must correspond with the user's
service provider. Choose the one corresponding
to the SIM card among the list of compatible
providers.
Synchronize:
(1/2/6/12 times
a day)
Sets the daily number of synchronisations
between the camera and the server.
This option changes the frequency at which the
camera communicates with the
mySPYPOINT
server in order to update its status or to send
photos on the user’s account.