Spypoint SMART-PRO User Manual - page 11
11
I.T.T. presets
Two I.T.T. Presets are available; Trail and Feeder. Each have an ideal confi-
guration for its respective usage. After selecting a preset, no configuration
is required. Simply choose between photo or video mode; the test light in
front of the camera will flash for 60 seconds to allow the user to leave the
area without being photographed.
TRAIL PRESET
The trail preset is configured for usage in trails. It is more effective
when these conditions are met:
•
Low activity level: a small number of animals pass by.
•
Fast subjects: animals are in movement
•
Small number of photos: few ocurrences are expected and
subjects are close to the camera.
FEEDER PRESET
The Feeder preset is configured for usage at a feeder's site. It is
more effective when these conditions are met:
•
High activity level: many animals pass by.
•
Slow subjects: animals stay in place for a long time.
•
Large number of photos: a lot of occurences are expected and
subjects are far from the camera.
CAMERA
CAMERA
I.T.T. TECHNOLOGY
The two I.T.T. presets (Trail and Feeder) are configured by default with the
I.T.T. mode (Intelligent Triggering Technology).
PHOTO (I.T.T.)
On detection, one photo is taken. If a new movement is detected by the
camera, a second photo is taken within 60 seconds after taking the first
photo. This mode allows the user to always have a subject on the photo.
VIDEO (I.T.T.)
A video of 10 seconds is taken upon detection. If the subject only passes
in front of the camera, it takes only one video of 10 seconds. If the sub-
ject continues to move in front of the camera, the video recording is then
prolonged by 10 second sections, to a maximum of 90 seconds. This mode
allows the user to record the best of the action.
CAMERA
CAMERA
15s
30s
45s
60s
0s
Photo #1
Photo #2
In TRAIL preset, the photo resolution
is set to 8 MP to allow a faster trigger
speed.