Square Scrub Doodle Scrub EBG-9 Owner's Manual - Problem
page 7
Problem
Cause
Action
Unit runs correctly but stops. It
works fine after 3-10 minutes
Incorrect pad is being used.
Only use pads recommended
by Square Scrub. Pads are not
to exceed “5.25”x”10.5”.
SS P0511BLU - Driver Pad
SS P0511DRIVER - Thin Pad
SS P0511SHO - Wet Strip Pad
SS P0511SQP - Dry Prep Pad
SS P0511WHT - Thick Pad
SS P0511XTR - Dry Earase Pad
SS P0511TGB - Blue Tile &
Grout Pad
Maximum Wet Weight: 5oz.
***NOTE: DO NOT USE GREEN
TILE AND GROUT PAD ON THE
EBG-9 DOODLE SCRUB.
Use correct pad. If problem continues
contact your nearest Square Scrub
Dealer.
Machine will not start
Not Connected to power source
Voltage too low
Defective switch
Check power source connection and
lighted plug
Have electrician check outlet
Contact Square Scrub dealer
Runs erratically
Low voltage from excessive
length or undersized
extension cord
Defective start switch
Defective motor low voltage
Use 10 gauge extension cord
Not more than 25’ long
Contact Square Scrub dealer
Contact Square Scrub dealer
Fuse/Circuit Breaker Trips
Low voltage
Low input volts
Allow the motor to cool.
Eliminate extension cord.
Locate power cord closer to work site.
Have voltage checked by
electrician.
Machine pulls hard to one side
Note: The rubber isolators on the EBG are
considered wear items. It is recommended to
replace the entire set of all four isolators once
per year (or sooner under heavy use) to prevent
failure and damage to the machine.
Worn Pad
Rubber isolators are worn out
Rotate pad 180 degrees
Flip pad over
Replace Pad
Replace isolators
Machine is noticeably louder than
it was when originally purchased
Rubber isolators worn
Replace isolators
Troubleshooting