SVS 12HSE LIFT Installation Instructions Manual - page 12
Cable Management is used to keep projectors cables away
from the scissors during Lift operation. Do not attach the
projector cables to the scissors of the Lift as they could be
repeatedly pinched when the Lift raises and lowers. See
Figure 11.
Dual Accessory #7 Cable Retractor are standard equipment
on all SVS 12HSE Series Lifts. The Cable Retractors are a
spring-loaded reel on the rear of the Lift. The retractor
automatically retracts your cable as the Lift ascends and
releases your cable as the Lift descends.
Warning: Over-winding the reel or winding the reel
counter-clockwise will damage the cable reel springs.
Broken cable reel springs are not be cover by the Lifts
warranty.
Instructions:
1. Please read all instructions before installing your
cable on the Cable Retractor cable reel.
2. Lower the Lift to its maximum down position
(Service position).
3. Clamp your cable securely to the outrigger on the
top frame of the Lift. See Figure 10.
4. Wind the cable reel clockwise:
7 complete turns for the SVS 12HSE-24
8 ½ turns for the SVS 12HSE-29
9 ½ turns for the SVS 12HSE-33
5. Hold the cable reel in this position to stop the reel
from unwinding.
6. Attach upper half of your cable to the cable reel
between two of the four (4) holes with 3/16” tie-
wraps. Leave the tie-wraps semi-loose in case
adjustment is needed. See Figure 11.
7. Make one and a half turns around the cable reel
counter clockwise with your cable. Lock your
cable in the same way as in Step 6, to the two
remaining holes (180
°
from the first holes used.)
8. Clamp your cable securely to the outrigger on the
bottom frame of the Lift.
9. Run the Lift up and down to check the slack in
your cable. Your cable will be slacked at the top of
the Lift when the Lift is in a full up position, and
equally slacked at the bottom in a full down
position.
Note: The Cable Retractor is located near the center of the
scissors, but due to different number of scissors and the
opening time of the scissors, there can be slack in your cable above or below the cable reel as the Lift lowers.
SVS 12HSE Lift Installation Instructions
Page 12 of 16
Figure 11a. Cable Retractor (inside view)
Figure 10. Cable Retractor