SVS 12HSE LIFT Installation Instructions Manual - page 13
Excess slack can be removed by adjusting the cable
clamping on the cable reel after tracking the Lift up &
down. If the slack is adjusted correctly, the cable will be
more even when in the up and down positions, with slack
occurring only in the middle position.
10. When proper cable tension is achieved, you can
securely tighten the tie-wraps.
12. SETTING THE SHOW POSITION
The Show position is adjusted by positioning the Show
position microswitch located on the rear right of the
Lift's top frame so that the large roller washer
compresses the Show position switch when the Lift
reaches the Show position.
1. Place the key switch in the Service position and
lower the Lift to the desired Show Position.
2. Loosen the thumb screw holding the Show microswitch (bracket) in place and slide the Show
microswitch (bracket) along the Lift frame until the large roller washer compresses the microswitch. You
should hear a slight click as you position the microswitch over the washer and the microswitch is
compressed.
3. Moving the Show microswitch toward the rear of
the Lift raises the Show position and moving the
Show microswitch toward the front of the Lift
lowers the Show position.
4. Tighten the thumb screw. Make sure that the
microswitch is not positioned too close to the
washer because the washer must be able to pass
under the microswitch to reach the Service
position.
5. The Show position is now set. Raise the Lift to a
closed position and place the key switch in the
Show position and press the toggle switch down.
The Lift will lower and stop at the Show position
you set. It maybe necessary to repeat steps 1
through 3 to get the Show position set where you
want it.
6. The Lift will only stop at the Show position when lowering from above the Show position and not when
rising from below the Show position.
7. The Show position is adjustable with an accuracy of
+
/- 1/8-inch (0.32 cm).
13. MAINTENANCE AND ADJUSTMENTS
SVS 12HSE Lift Installation Instructions
Page 13 of 16
Figure 12. Show Position Adjust
Figure 11b. Cable Retractor (side view)