SVT Innovations SVT-2 User Manual - page 7
DIP Switch Setting
The DIP switch is designed to set the code for door station and monitor, there are two states for
each DIP switch, please refer to the following sketch map.
Wiring diagram with SVT-2 AC31 camera:
The SVT-2 audio Outdoor Station A works as a Video Outdoor Station when connected to the SVT-2 AC31
camera.
Door station DIP setting
Indoor monitor DIP setting
Bit state
Description
ON(1)
=
OFF(0)
=
ON
ON
Total 3 bits can be configured, bit-1 and bit-2 are used to assign ID code for door station, bit-3 is
used to match the video impedance.The switches can be modified either before or after installation.
There are 6 bits in total. The DIP switches are used to configure the user code for Monitors.
Bit-6 is an video impedance match switch, which have to be set to ON if match the impedance,
otherwise set to OFF.
Bit-1~Bit-5 are used to set user code, to DT595A door station, the user code should set to 0~15.
Please refer to the following settings:
Note: if the video impedance need to match, please set the bit-3 on.
1 2
3
ON
1 2
3
ON
1 2
3
ON
1 2
3
ON
ID = 0(00), set to the first door station
ID = 1(10), set to the second door station
ID = 2(01), set to the third door station
ID = 3(11), set to the fourth door station
AC~
SVT-2 PC6
ERL
SVT-2
Outdoor Station A
SVT-2 AC31
DS
IM
Bus PL S2+ S1+ S1-
OUT IN
-7-
Indoor
Monitor
Electric Lock Connection
Door Lock Controlled with Internal Power
EB
*
LOCK
Jumper position in 2-3
Bus PL S2+ S1+ S1-
1 2 3
Note:
1.
Electric lock of Power-on-to-unlock type should be used.
2.
The door lock is limited to 12V, and holding current must be less than 250mA.
3.
The door lock control is not timed from Exit Button(EB).
4.
The Unlock Mode Parameter on the Indoor Monitor must be set to 0 (by default).
One (1) lock connection: