SWAGTRON SWAGDRONE 210-UP Quick Start Manual - page 10
SWAGTRON
®
SWAGdRONe
TM
210-UP Racing Quadcopter Quick Start Guide
10
• Do not move the SwagDrone 210-Up during binding.
If the error reading THST K or any other combination appears on the remote’s
screen, at least one of the trims, dials, or sticks is not in the correct position. Turn
the controller off, check the above
image, make any needed adjustments,
and turn it on again.
STEP4. Once the drone successfully binds
to the controller, the red LED will
blink slowly and the drone should
stop making noise.
In the event that everything has been done correctly but the buzzer keeps making
noise, please try binding the drone again. For any further troubleshooting, contact
customer service.
7.2 Locking & Unlocking the Motor
After successfully binding, the motor is locked by default.
Motor Unlock
Check that everything is in neutral (see Section 7.1, STEP 3),
then turn the remote on. Gently push the left stick down-left
and hold it in this position for at least 2 seconds. When the
motor unlocks, the right red LED light will turn on and the
drone will beep. Be very careful at this point, as pushing the
throttle up will start the motors.
You can test this by pushing the left stick up a little; the motors should start.
0
1
0
2
Left LED light
Right LED light
Back View
ELEV/RUDD
THRO/AILE
MODE 1
(Throttle stick on the right)
MODE 2
(Throttle stick on the left)