SWAGTRON SWAGDRONE 210-UP Quick Start Manual - page 9
SWAGTRON
®
SWAGdRONe
TM
210-UP Racing Quadcopter Quick Start Guide
9
7.1 Binding Your SwagDrone
• PROCEED WITH CAUTION. The drone will immediately receive power to all parts including the
propellers once the battery is connected. Do not allow loose clothing, hair, fingers or any other
part of your body to come in contact with or near the propellers during battery installation.
STEP1. Set the drone on a flat, level surface
and check that the battery is secured
in its compartment and that the
Mushroom Antenna is securely
attached.
For your safety, it is recommended to
extend both the Receiver Antennas
before the next step.
STEP2. Connect the battery to the drone using the matching connectors. Make sure that the
red and black cables match the cables underneath the battery compartment. Once
the battery is connected, the drone will make noise, the left red LED light should
turn on, and the propellers may move slightly. Move at least 15 feet away for safe
clearance.
STEP3. Put the function switches to the 0 position and place the trims and dials to the
middle positions. Doing this puts everything in neutral. Use the image on the next
page to check that everything is in the correct position then turn on the remote
control. The controller will automatically start to bind to the drone once it is on.
With everything in the correct positions (neutral), turn on the remote. The controller
will automatically start to bind to the drone once it is on.
Left LED light
Right LED light
Back View
90°