T+A CM Active Mini User Manual - page 13
13
Setting up, connections, the speakers in use
Unpacking
Please unpack your
loudspeakers and accessories very
carefully. The contents of the set are as follows:
2
- loudspeaker cabinets
1 set of operating instructions
2 mains leads
2 RCA leads
8 felt pads
2 foam plugs
Please store the original packaging materials in a safe place. The carton and
packing materials have been specially designed for these loudspeakers. They
form a safe container should you need to transport the speakers at any time,
and they also help to maintain the speakers’ second-hand value.
If you don’t wish to keep the packaging, give the material back to your supplier
for appropriate disposal.
Setting up
It is essential to provide for unobstructed air circulation around the speaker
cabinet. If you set up the speakers on a shelf or in a cabinet, there must be at
least 10 cm space at the sides of the back panel and the top panel of the
speaker cabinet.
The CM Active Mini is an excellent choice for listening at close range. At the
development stage we also took into account the speaker’s position: it works
equally well on a large, flat area
– such as a sideboard – or close to the wall.
However, if the bass is too powerful, please use the foam plugs supplied to
close the bass reflex duct on the rear of the cabinet.
Setting up the speakers in the immediate vicinity of a conventional (CRT) TV set
The
loudspeakers should be positioned at least 1.0 metres
from any conventional television, otherwise they may cause discoloration of the
TV image. This restriction does not apply to LCD or Plasma TV sets.
Connections
Conn
ect the loudspeakers’ Cinch audio inputs to the outputs of your pre-amp-
lifier.
Connect the supplied external mains PSU to the DC socket on the rear face of the
loudspeaker and the mains plug to a wall socket.
The speakers are ready for use. A LED lights up to indicate the ready status.
The LED is located behind the grille on the lower part of the front panel.