T+A CM Active Mini User Manual - page 14
14
Using the automatic
power-on circuit
The
loudspeakers are fitted with an automatic power-on circuit
which turns the speakers on from stand-by mode when a music signal is
present, and turns them off again about ten minutes after the music has ended.
The power consumption of the loudspeakers in stand-by mode is very low (less
than 0,5 Watt).
If you know you will not be using the speakers for a long period, disconnect
them completely from the main supply.
If your pre-amplifier features switched mains outputs, the speakers can also be
connected to them and operated in this way.
Use with the
If you connect the speakers to a
Multi-Source System, then the
can be switched on by a trigger signal from the
. In
this case the loudspeakers are always switched on with the
– not just
when the music starts. This eliminates the possibili
ty of “swallowing” the initial
beats of the music.
(for details see the
operating instructions)
Using the
without wire stand
If you don’t want to install the speaker on the wire stand,
please close the mounting holes at the bottom side by the selfsticking felt slide
washers supplied with the speaker!