T&D RTR-5W Introductory Manual - page 4
9.
Downloading Recorded Data
It is possible to download recorded data by two methods: [Wireless Communication] or
[Optical Communication].
NOTE:
If the computer clock is set incorrectly, the time of the downloaded data will also be
incorrect. Make sure the clock settings are correct before starting a downloading session.
Ex) Download Data by Wireless Communication
1.
Open
RTR-5W for Windows
.
2.
From the Administration Tree, select the Remote Unit from which you
wish to download data, and in the "Data" Menu, select "Download Data".
[Download]
button
Specify the
download range
[Open Graph]
button
[Specify the File Name]
button
The selected
Remote is
displayed.
3.
Select the Download Mode.
4.
If you wish to save the file by specifying the location, click the [Specify
File Name] button and make Saving Location Settings.
5.
Click the [Download] button to start downloading.
After downloading has been completed, select the name of the Remote Unit
from the list and click "Open Graph" to view the data in graph form.
10.
Viewing the Current Readings Monitor
(accessing via browser)
1.
Open Internet Explorer.
2.
In the address, enter the IP address that was entered in the
Network
Settings Utility
in the form of a URL that begins with http://...and then
press the [Enter] key. The RTR-5W Series Web Viewer will appear.
After this, anytime you wish to view an already initialized RTR-5W, enter the address
as above, and press the [Enter] key to open the RTR-5W Web Viewer.
Enter address
[If the Viewer does not appear]
Check the IP address and subnet mask, and repeat the steps in "3. Network Initialization
Settings".
3.
Once the RTR-5W Web Viewer is displayed, the current readings monitor
for all Remote Units registered to that RTR-5W will automatically appear.
In the Current Readings Monitor, gathered data will appear from the Remote Unit(s) at the data
gathering interval set in the "Location Properties" in
RTR-5W for Windows. If you wish to view
the most recent readings, click the [Gather Current Readings] button.
[Gather Current Readings]
button
6.
Placing a Remote in the Field
The wireless communication range, if unobstructed and direct, is about 100 meters [330
feet. ].Place the Remote Unit(s) within 100 meters of the RTR-5W Station in a spot where
stable wireless communication can occur.
7.
Wireless Communication Test
Gather the current data readings from each Remote Unit and check to make sure that
wireless communication is possible between the Remote Units and the RTR-5W Station.
1.
Place a Remote Unit in the actual place from which you wish to measure
and record data.
2.
Select the placed Remote Unit from the Administration Tree, and in the
"Data" Menu, select "Gather Current Data".
* By right clicking on the Remote Unit icon, a popup menu will appear where you can select
"Gather Current Data" to display the "Gathering Current Data" window.
3.
Click the [Gather] button to start communication with the Remote Unit
and the current data readings will be displayed.
If the current readings are not displayed, move the Remote Unit to a different Location and
try gathering the current data again.
8.
Starting Recording
NOTE:
If the computer clock is set incorrectly, the programmed start time will also be incorrect. Make sure
the clock settings are correct before starting a recording session.
1.
Open
RTR-5W for Windows
.
2.
From the Administration Tree, select the Remote Unit for which you
wish to make recording settings, and in the "Settings" Menu, select
"Start/Stop Recording".
3.
Set the Recording Conditions.
4.
Click the [Start Recording] button to send the recording condition
settings via the RTR-5W Station to the Remote Unit and complete the
set-up.
[Gather]
button
The selected
Remote is displayed.
© Copyright T&D Corporation. All rights reserved. 2010.08 16507020008 3rd Edition