T-Eye ADR-3000 User Manual - Functions Of Each Part
12
Functions of each part
Forward facing and rear facing/interior view camera
The camera must be horizontal and vertical. When the lens of the camera is obstructed or
is dirty, clear images may not be captured. Periodic cleaning is required. To clean the lens,
use a soft camera lens cloth to prevent damage.
Emergency record button (Video image removal protection)
In order to record driver detected scenes of interest, press the emergency record (E)
button to record. This stores and records 1 minute before and 1 minute after the driver
pressing this event button. (The User may set pre-event time 1 minute, 2 minutes or 3
minutes). These events will not be erased unless the User cancels the capture by
pressing the M button or the file is erased using the software. (A remote button is also
provided for this function for covert recording) The recording time is determined in
prerecording time.
SD Card slot
Before inserting or removing the SD Card, TURN OFF the power of the unit.
Make sure you should set the time zone in T-eye configuration before start.
To replace the SD card with a new one,
1.
Format the new SD card as follows;
2GB, 4GB, 8GB or higher: FAT32,
less than 2GB:FAT
2.
Copy “Player” folder from used SD card and paste to new SD card.
Emergency Record Protection Cancel Button
Press the button for about 3 seconds until chimes “ding dong”. All the previous event
record protection is cancelled to be able to overwrite. When the unit record as Emergency
Record, it also can cancel the emergency record protection.
Volume control
Adjust the audio volume level for driver’s convenience. When you turn it left (<<), it
increases the volume while a right (>>) turn decreases the volume.
Power connection port
Connect one end of the cigarette lighter plug cable into the matching connector of the
power port of the unit. Plug the other end of this cable to the cigarette lighter plug of the
vehicle. {Power may be hard wired (permanently wired) into the ACC (accessory) switched
power of the vehicle for a more secure installation. REFER THIS TO TRAINED PERSONEL
ONLY.} Do not lose the supplied power cord or use other cables. If damaged or lost,
contact your Reseller for a replacement.
LED Display window
The LED display Shows the current status of T-Eye and other features, for further
understanding of displayed messages please refer to the table on page 21