Tactic Any Link Instruction Manual - Aileron
5
3. Apply power to the Rx and servos in the model. If setting up a
Tx/AnyLink to the Tactic Rx for the first time, insert a small diameter
screwdriver in the hole on the Rx marked “BIND”. Press and hold
the button until the Rx LED turns on, then off after about one
second. Release the bind button, and the LED should turn on if
binding was successful. Check to make sure all Tx controls are
properly mapped at the Rx, as listed in the table.
CHANNEL 2
Aileron
Elevator
CHANNEL 3
Elevator
Throttle
CHANNEL 1
Aileron
Throttle
CHANNEL 4
Rudder
Rudder
FUTABA and HITEC
NORMAL CHANNEL MAPPING
JR and SPEKTRUM
See page 7 for complete failsafe details.
4. If all channels are mapped properly, skip to page 7 for more
details regarding Rx operation. If some channels are NOT mapped
correctly, or you prefer to manually change the channel mapping,
proceed to the ALTERNATE CHANNEL MAPPING section below.
ALTERNATE CHANNEL MAPPING
To manually switch AnyLink to alternative channel mapping:
1. Remove power from the Rx and servos in the model.
2. Center the Tx rudder trim, and move the throttle stick to minimum.
3. For Futaba and Hitec transmitters, turn the power switch OFF.
For JR/Spektrum transmitters, disconnect the “Power Plug” from
the Tx charge jack.
4. Move the Tx rudder stick to the far bottom-left or bottom-right
corner and HOLD IN THIS POSITION.
5. For Futaba and Hitec transmitters, turn the power switch ON. For
JR/Spektrum, re-connect the “Power Plug” to the Tx charge jack.