Tactic Any Link Instruction Manual - page 9
9
Channel Mapping: If controls in the model do not function according
to the control inputs from the Tx, reset the system by repeating all
steps in the AnyLink Operation section on page 4. Proceed to the next
step once all channels are mapped properly.
Range Check: Determine the safe operating distance from the Tx to
the Rx. With the assistance of another person, place the aircraft on the
ground and walk 100 feet (30m) away from the model. Confi rm that
smooth, interference-free control of all surfaces exists.
Failsafe Check: If using the failsafe feature on a Tactic Rx, test for
proper operation as follows:
1. Prepare a way to quickly disconnect the battery/ESC connection if
power needs to be cut immediately.
2. Have an assistant hold the aircraft in place on a test stand, with
hands away from the motor.
3. Apply power to the system and test the motor and fl ight gear for
general operation.
4. Remove power from the Tx/AnyLink: turn off the power switch on
Futaba/Hitec transmitters, or for JR/Spektrum transmitters disconnect
AnyLink’s power plug from the Tx charge jack.
5. Observe the model’s surfaces to ensure they move to the previously
set failsafe positions.
6. If failsafe operation is correct, re-connect power to the system as
explained earlier and prepare for fl ight. If the failsafe function does
not operate correctly, re-check the TACTIC RECEIVER and SYSTEM
CHECK AND OPERATION sections and re-try.