Tactic Any Link Instruction Manual

Other manuals for Any Link: Instruction Manual
Manual is about: 2.4GHz

Summary of Any Link

  • Page 1

    The anylink slt ™ 2.4ghz radio adapter allows many r/c aircraft transmitters (tx) to link with tactic’s ultra- small, lightweight, and inexpensive 2.4ghz receivers (rx), and transmitter-ready ™ (tx-r ™ ) aircraft. Compatible transmitters can originally be designed for use on 72mhz, 2.4ghz, fm, pcm, ...

  • Page 2: Tx Compatibility and Cords

    2 tx compatibility and cords all compatible transmitters must have a trainer/dsc jack. An adapter cable connects anylink to the tx trainer jack. The included cable with two plugs is for futaba ® and tower hobbies ® transmitters having a square trainer jack (except futaba 12z, 14mz, 18mz, and 4yf on ...

  • Page 3: Anylink Setup

    3 anylink setup important! Remove the airplane’s propeller prior to setting up anylink to work with the flight system. Failure to do so could result in personal injury if the motor turns unexpectedly. Make sure all batteries are fully charged prior to operation. Make sure all connections are solid p...

  • Page 4: Hitec Radios

    4 3. Turn the tx power switch on. For computer radios having the option to transmit a signal when tx power is turned on, make sure “yes” is selected. 4. Anylink should sound one beep and its led should illuminate. 5. Skip to the compatible receivers section on page 5. Hitec radios 1. Connect the app...

  • Page 5: Compatible Receivers

    5 2. Insert the 3-pin connector into anylink’s input jack. 3. Connect the cable’s remaining plug to the tx charge jack. 4. Anylink should sound one beep and its led should illuminate. 5. Proceed to the next section. Compatible receivers anylink is compatible with tactic brand 2.4ghz receivers such a...

  • Page 6: Elevator

    6 2. Cycle power on anylink by removing – then re-inserting the 3-pin connector in the input jack. 3. Anylink’s led will turn on. Wait 5 seconds and anylink will sound three tones • • • . 4. Release the stick back to neutral position. Anylink should sound two tones • • to indicate the order of chann...

  • Page 7: Binding to A Tactic Rx

    7 binding to a tactic rx to use anylink with a micro tx-r airplane, skip to the next section. Otherwise, when binding to a tactic brand rx or select scale tx-r aircraft, anylink’s factory default setting is to pass all channels to the rx in the same order as from the host tx, as shown in the chart b...

  • Page 8

    8 failsafe: all tactic tr624 receivers include a failsafe function, where rx ch3 deflects to 0% (minimum) which should stop motor function if the rx loses signal. The deflection position of this servo can be changed manually, if desired. All other channels will hold their last position. If using a j...

  • Page 9

    9 auto-binding anylink to micro tx-r aircraft these procedures apply if using futaba, hitec, and tower hobbies transmitters, in addition to jr, spektrum, and graupner transmitters which have been re-configured to alternate channel mapping as described earlier. When power is originally applied to a m...

  • Page 10: System Check and Operation

    10 system check and operation check the general operation of the system and all flight equipment before attempting a flight. Warning! With the aircraft on the ground, make sure the throttle stick remains at the minimum position and is not accidentally moved. Note: micro tx-r aircraft have a throttle...

  • Page 11: Specifications

    11 inactivity alarm and power-down procedures if the tx sticks are not moved for 4 minutes, anylink will sound tones to alert that power is still on and anylink is still transmitting a signal. After power has safely been removed from the model, power must be removed from anylink. For futaba, hitec (...

  • Page 12: Troubleshooting

    12 ● do not allow chemicals to come in contact with any parts of anylink. Substances such as glow fuel, gasoline, ca glue, etc. Could permanently damage the case and electronic components. ● always follow the academy of model aeronautics national model aircraft safety code when operating an r/c airc...

  • Page 13: Fcc Statement

    13 fcc statement this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions. (1) this device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation. Fcc rf radi...

  • Page 14: Declaration of Conformity:

    14 declaration of conformity: product: tactic anylink slt 2.4ghz radio adapter item number: tacj2000 equipment class: 1 tactic anylink slt 2.4ghz radio adapter: the objects of the declaration described here are in conformity with the requirements of the specifi cations listed below, following the pr...

  • Page 15: Hobby Services

    15 1-year limited warranty – *u.S.A. And canada only tactic warrants this product to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase. During that period, tactic will, at its option, repair or replace without service charge any product deemed d...