Tactic Any Link Instruction Manual - System Check and Operation
10
SYSTEM CHECK AND OPERATION
Check the general operation of the system and all flight equipment
before attempting a flight.
WARNING! With the aircraft on the ground, make sure
the throttle stick remains at the minimum position and is
not accidentally moved. NOTE: Micro Tx-R aircraft have a
throttle arming procedure which does require movement of the
throttle channel during setup (see instructions included with the
Micro Tx-R aircraft).
RANGE CHECK: Determine the safe operating distance from the Tx
to the Rx. Place the aircraft on the ground and walk 100 feet (30m)
away from the model. Confi rm that smooth, interference-free control
of all surfaces exists.
FAILSAFE CHECK: If using the failsafe feature, test for proper
operation as follows:
1. Prepare a way to quickly disconnect the battery/ESC connection if
power needs to be cut immediately.
2. Have an assistant hold the aircraft in place on a test stand, with
hands away from the motor.
3. Apply power to the system and test the motor and fl ight gear for
general operation.
4. Remove power from the Tx/AnyLink.
5. Observe the model’s surfaces to ensure they move to the previously
set failsafe positions.
6. If failsafe operation is correct, re-connect power to the system as
explained earlier and prepare for fl ight. If the failsafe function does
not operate correctly, re-check the LINKING WITH A TACTIC Rx
and SYSTEM CHECK AND OPERATION sections and re-try.
7. After the fl ight is complete, remove power from the fl ight system as
soon as possible.