Tactic Any Link Instruction Manual - Hitec Radios
4
3. Turn the Tx power switch on. For computer radios having the
option to transmit a signal when Tx power is turned ON, make sure
“YES” is selected.
4. AnyLink should sound one beep and its LED should illuminate.
5. Skip to the COMPATIBLE RECEIVERS section on page 5.
HITEC RADIOS
1. Connect the appropriate cable to the Tx trainer jack. NOTE:
For Optic 5, Optic 6 Sport, and Eclipse 7 transmitters on 2.4GHz,
refer to the instructions included with the required optional
Power Adapter TACM0005 for specific setup details. For Aurora
9 transmitters, refer to the instructions included with the required
optional cable TACM0004 for specific setup details.
2. Connect the cable’s 3-pin connector to AnyLink’s INPUT jack.
3. Turn the Tx power switch on.
4. AnyLink should sound one beep and its LED should illuminate.
5. Skip to the COMPATIBLE RECEIVERS section on page 5.
JR, SPEKTRUM, GRAUPNER MX-16 RADIOS
IMPORTANT! NEVER turn the JR, Spektrum, or Graupner
Tx power switch to the ON position at any time when using
with AnyLink! Doing so will cause AnyLink to stop transmitting its
signal and result in a loss of control of the model. When flying is
finished and power has safely been removed from the model and
AnyLink, it’s also necessary to disconnect the plug from the
transmitter’s trainer/DSC jack to prevent accidental full discharge
of the transmitter’s own battery.
1. Connect the appropriate cable to the Tx trainer jack. The
transmitter’s logic circuit will turn on automatically. NOTE: For
Spektrum DX4e, DX5e, DX7s, DX8, DX10t, and DX18 transmitters,
refer to the instructions included with the required optional Power
Adapter TACM0005 for specific setup details.