Tactic Any Link Instruction Manual - Anylink Setup
3
ANYLINK SETUP
IMPORTANT! Remove the airplane’s propeller prior to
setting up AnyLink to work with the flight system. Failure
to do so could result in personal injury if the motor turns
unexpectedly. Make sure all batteries are fully charged prior to
operation. Make sure all connections are solid physically and
cannot easily become dislodged at any time. AnyLink must be
used with a Tx having a throttle stick that does NOT automatically
spring back to center.
1.
Using the included hard locking
mounting strips, mount AnyLink high
on the rear of the Tx, extending its
antenna upwards from the top of the Tx
as much as possible as shown at right.
Also note the location of AnyLink’s
INPUT jack.
2. Remove the Rf module or crystal,
or disable the Rf section in the host
Tx if possible.
3. Leave the Tx’s own antenna in a
retracted or folded position.
4. For computer radios make sure the modulation is set to PPM mode.
5. Move the throttle stick to minimum; leave all other sticks at center.
6. Go to the appropriate section below depending on the brand of
transmitter being used.
FUTABA AND TOWER HOBBIES RADIOS
1. Carefully connect the appropriate cable to the Tx trainer jack.
NOTE: For Futaba’s 12Z, 14MZ, 18MZ, and 4YF on 2.4GHz,
refer to the instructions included with the required optional Power
Adapter TACM0007 for specific setup details.
2. Connect the cable’s 3-pin connector to AnyLink’s INPUT jack.
Input Jack
Cable