Tactic Any Link Instruction Manual - Binding to A Tactic Rx
7
BINDING TO A TACTIC Rx
To use AnyLink with a Micro Tx-R airplane, skip to the next section.
Otherwise, when binding to a Tactic brand Rx or Select Scale Tx-R
aircraft, AnyLink’s factory default setting is to pass all channels
to the Rx in the same order as from the host Tx, as shown in the
chart below:
CHANNEL 2
Aileron
Elevator
CHANNEL 3
Elevator
Throttle
CHANNEL 1
Aileron
Throttle
CHANNEL 4
Rudder
Rudder
BINDING WITH A TACTIC Rx
FUTABA, HITEC
JR, SPEKTRUM, GRAUPNER
1. With power already applied to the Tx/AnyLink as explained
earlier, move the Tx throttle stick to MINIMUM.
2. Apply power to the Tactic Rx.
3. Insert a small diameter screwdriver into the hole on the Rx
marked “BIND”. Press and hold the pushbutton until the Rx LED
glows red and then turns off after about one second.
4. Release the “BIND” button. The LED will turn on if linking was
successful. This link should remain intact for future uses, in which
case the Rx LED will turn on immediately when power is applied
to the Rx. If the link did not remain intact, repeat this binding
procedure.
5. Confirm all servo controls function properly according to inputs
on the Tx sticks.
6. If you do not wish to set a failsafe in the Tactic Rx, skip to the
SYSTEM CHECK AND OPERATION section on page 10.