Tactic Any Link Instruction Manual - Specifications
11
INACTIVITY ALARM AND POWER-DOWN PROCEDURES
If the Tx sticks are not moved for 4 minutes, AnyLink will sound
tones to alert that power is still ON and AnyLink is still transmitting
a signal. After power has safely been removed from the model,
power must be removed from AnyLink. For Futaba, Hitec (except
Optic 5 and 6 Sport and Eclipse 7 on 2.4GHz), and Tower Hobbies
transmitters, turn the Tx power switch OFF.
For JR, Spektrum, and Graupner transmitters, and Hitec Optic 5
and 6 Sport and Eclipse 7 on 2.4GHz, disconnect AnyLink’s power
plug from the Tx charge jack. AnyLink’s LED will turn off. Also
remember to remove the plug from the Tx trainer jack.
SPECIFICATIONS
Compatible Rx’s: Tactic brand receivers
Frequencies:
2.403 – 2.480GHz
Modulation:
FHSS spread spectrum
Power indicator:
LED with audible tones
Inactivity alarm:
audible tones after 4 minutes of Tx stick inactivity
Output power:
< 0.1W
Case dimensions: 64 x 36 x 12mm (2.5 x 1.4 x 0.5")
Weight:
24g (0.85 oz.)
IMPORTANT WARNINGS AND PRECAUTIONS
● Do not allow water or moisture inside AnyLink.
● Do not operate R/C model aircraft near power lines, radio or cell
phone towers, roads or automobiles, buildings, or pedestrians.
● Do not operate R/C equipment if you are physically impaired as
it could pose a safety hazard to yourself or others in the area.
● Do not allow small children to operate/control model R/C
equipment without the supervision of an adult.
● Do not allow the Tx’s throttle stick to accidentally be moved away
from the “off” or minimum position while the model’s engine/motor
is running.