TAG MCLAREN AUDIO 60IRV Owner's Manual - page 8
Your 60iRv has six line level inputs which can be selected by
name
(1)
. The input for listening can be selected independently
from the input for recording so you can listen to one source and
record another at the same time.
The signal from your chosen input source will be amplified and
sent to the loudspeaker terminals, the headphone socket and the
preamplifier output. To select your source, turn the INPUT selector
until the mark on its side points to the name of the input that you
want to listen to.
You can also select an input for listening by pressing the button
on the remote control marked with the name of the input
(3)
.
The remote control can also be used with selected TAG McLaren
Audio F3 Series CD players. For details, please see the separate
remote control instructions.
The signal from the input that you select for recording will be sent
to the record output sockets marked TAPE out 1, out 2 and out 3
(4)
.
To select your source for recording, turn the RECORD selector
until the mark on its side points to the name of the input that you
want to record
(5)
.
The record output is not affected by the muting or volume controls.
inputs for
listening
using the
remote control
inputs for
recording
cd
tuner
R E C O R D
aux
tape 1
tape 2
tape 3
left
right
E
M P
out
3
in
out
2
in
out
1
in
T A P E
14
15
selecting an input
selecting an input
1. The inputs for cd, tuner, aux, TAPE 1, TAPE 2 and TAPE 3 are all the same
electrically. They are named for your convenience
2. In some operating modes the preamplifier output is isolated (see page 16)
3. When you use the remote control, the INPUT knob on the front panel will turn
automatically to point to the input selected. Make sure that nothing interferes
with the free movement of the knob when you use the remote control
4. The TAPE out 1, out 2 and out 3 sockets are connected together internally and
are identical electrically
5. A loop is created if a tape recorder output and input are both connected to your
60iRv and the same tape recorder is selected as the record input. This may
cause feedback if your recorder is set to record. To avoid this possibility we
recommend that you select the input for recording before you set your recorder
to record.
aux
tuner
I N P U T
cd
tape 1
tape 2
tape 3
GRA00046.1-[CA]60iRv 12/03/01 15:20 Page 15