Tait TP9400 Series P25 User Manual - Charging The Battery

 Charging and caring for batteries  149

Charging the battery

Fully charge a battery before using it for the first time. 

This will take up to 2.5 hours.

The red LED stays lit while the battery charges.

To charge the battery:

1

Desktop charger: Connect the charger to the 

correct Tait power adaptor.

Multicharger and vehicle charger: Power on the 

charger.

Initially, all three LEDs are lit for two seconds.

2

Place just a battery in the charger, or a radio with 

a battery attached (desktop charger or 

multicharger only). There is no need to remove a 

belt clip, antenna, or any accessory that is 

attached to the accessory connector.

The red LED lights up, and stays lit while the 

battery charges. For a battery that is almost 

completely discharged, allow two hours.

When charging is complete, the green LED

stays 

lit.

Charger for IS batteries only

Notice 

Placing a fully charged battery into the 

charger for IS batteries may result in both the orange 

and red LED lighting up. In this case, remove the 

battery and use as normal. Leaving the battery in the 

charger may result in the battery being discharged.