Tait TP9400 Series P25 User Manual - Use
32 Before using your radio
The diagram below shows the specified dimensions of
the label.
Charging the battery before first
use
Before using your battery for the first time, you must
charge it. Follow the instructions included with your
Tait charger. This information is repeated in the
"Charging and caring for batteries" on
For best charging performance, switch off the
radio before placing it in the charger.
Attaching the battery
Warning
Use only a Tait-supplied, IS-approved
battery with an IS radio.
Notice
Fit the bottom edge of the battery to the radio,
then the top edge. Attempting to fit the top edge first
may damage the contacts.
1
Rotate the power/volume control switch
counterclockwise to turn off the radio.
If the battery has been attached while the radio
is turned on, turn the radio off and then on again
before use.
2
Holding the radio firmly, align the back of the
battery with the back of the chassis.
R0.13 in
(3.2 mm)
maximum label thickness: 0.03 in (0.8 mm)
0.28 in
(7 mm
)
1.22 in (31 mm)