Taiwan Electrical & Electronic Manufacturers N930R User Manual - page 4
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does not cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encourage to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the device and receiver
•
Connect the device into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/television technician for help.
You may find helpful the following booklet, prepared by the Federal Communications
Commission: Interference Handbook (stock number 004-000-00345-4). This booklet is
available from the U.S. Government Printing Office, Washington, DC20402
Warning: The user must not modify or change this computer without approval. Modification
could void authority to this equipment.
Canadian Department of Communications
Compliance Statement
This Class B digital apparatus meets all requirement of the Canadian Interference-Causing
Equipment Regulations.
Shielded Cables Notice
All connections to other computing devices must be made using shielded cables to maintain
compliance with FCC regulations.
Peripheral Devices Notice
Only peripherals (input/output devices, terminals, printers, etc) certified to comply with Class
B limits may be attached to this equipment. Operation with non-certified peripherals is likely
to result in interference to radio and TV reception.
Eng
lish
MANUAL INGLES OK 20/7/06 11:39 Página 3