Taiwan Electrical & Electronic Manufacturers N930R User Manual - Inserting Flash Memory Card

Inserting Flash Memory Card

To insert a flash memory card into the slot is similar to ExpressCard. You only need to pay

more attention whenever insert the flash memory card into the slot with the correct side.

For MMC and SD card, you should position the copper connector at the bottom side. For

Memory Stick card, you should position the copper connector at the topside. All of these

cards should be located at the center of the slots in inserting.

Only one correct side can be accepted for the 4 in 1 card slots. If you cannot insert the card

into the 4 in 1 slot or you had inserted the card but it is not recognized by the computer, ple-

ase remove the card and turn the card upside down and insert it again. To prevent the dama-

ge made both on card and the slot, never forced an entry into the slot with incorrect side. 

Removing Flash Memory Card

It is similar to ExpressCard for removing a flash memory card from the slot. You should first

disable the card setting in the system as described in the former section. 

To remove the flash memory card, you should only pull out the card by finger, there is no

release button for flash memory slot.

Eng

lish

Slot

Card type

Copper connector

4 in 1

SD (Secure

Digital)

MMC

(MultiMedia

Card)

MS (Memory

Stick)

MS_Pro

Bottom side

Bottom

Top side

Top side

MANUAL INGLES OK  20/7/06  11:40  Página 64