1. DL manuals
  2. TANDBERG
  3. Software
  4. 3000 MXP Profile
  5. Installation Manual

TANDBERG 3000 MXP Profile Installation Manual

Summary of 3000 MXP Profile

  • Page 1

    D13728.09 page 1 installation 3000/6000 profile for mounting of the wheel base, foot mount or wall mount, follow the respective instructions on page 2-6. 2 mounting wheel base foot mount wall mount 1 unpacking monitor bolts: wall bracket camera top module cable cover, back cover and base (wheel base...

  • Page 2

    D13728.09 page 2 wheel base 1 disassemble the foot from the column. Keep the bolts 2 assemble the column to the base with the 8 bolts from the foot 3 mount the top module to the column 1) use 4x type c bolts in front and on sides from underneath. 2) use 2x type b bolts behind, from above. Remove rub...

  • Page 3

    7 mount the camera pull cable through camera stand, and place it behind the monitor. Ensure that the camera stand is prop- erly connected to the magnets on top and behind. Plug cable to camera as shown on figure above. Place camera on top. The guide pin and magnets will ensure correct place- ment. P...

  • Page 4

    D13728.09 page 4 foot mount warning! Due to the size and mass of this equipment, it is very important that the wall mount unit is safely installed according to these installation instructions and that the wall is able to safely support the product. It is highly recommended that this foot mount unit ...

  • Page 5

    Caution! Be careful not to squeeze fingers or cables. Rearrange cables if necessary. D13728.09 page 5 wall mount warning! Due to the size and mass of this equipment, it is very important that the wall mount unit is safely installed according to these installation instructions and that the wall is ab...

  • Page 6

    Touch tones snapshot camera presets d13728.09 page 6 installation 2. Language open ‘general’. Select language and press save. 3b. Isdn configuration open ‘network - isdn settings’. Select isdn-bri settings or isdn-pri settings. Make isdn configuration and press ‘save’. 1. Open the control panel choo...