Tandberg Data StorageLoader Quick Installation Manual - page 3
Quick Installation Guide
1
Quick Installation Steps
For more information and complete step-by-step instructions, see
Tandberg StorageLoader
TM
Installation and User Manual.
Caution The transport locking screws must be removed before
the Tandberg StorageLoader
TM
can operate normally.
When following the steps listed, see the corresponding numbers on
the illustration below.
1 Unpack the StorageLoader and install the loader in a rack. For
instructions, see Tandberg StorageLoader
TM
Installation and User
Manual.
2 Connect the SCSI cables to the two SCSI connectors on the rear
of the loader.
a. Connect a cable between the host and a SCSI connector on
the StorageLoader. Secure the cable with the thumbscrews on
the connector.
b. If the StorageLoader is the last device on the bus, connect
a SCSI terminator to the other SCSI connector to terminate
the bus.
c. It is possible to daisy chain several devices on the SCSI bus.
If you do so the terminator must be connected to the last
device on the bus. Note that there are limitations to the length
of the SCSI cable. The maximum allowed length of an LVD
SCSI bus is 12 meters / 40 feet. Do not connect this device to
a SCSI raid controller/bus.