Target T11FOCH16 User manual - page 11
NOTE: It Is Very Important that the castor wheels
and mounting plates are fitted correctly.
•
Turn the heater upside down. Take care as
the heater is heavy.
•
Remove the wing nuts from the U-Bolts and
then position the U-Bolt between the end fins
and hold in place as shown.
•
Position the mounting plate (with wheels
attached) over the U-bolt threaded ends and
push down as shown.
NOTE: It is important that the mounting
plate be positioned with the two holes in the
side of the plate facing the control panel so
as to clear the two screw ends as shown.
•
Screw the Wing Nuts onto the U-Bolt ends
and tighten. Repeat for other side of U-Bolt
as shown.
IMPORTANT: This is the only time that you
should ever turn the Oil Filled
Heater on its side or upside-
down.
•
Fit the castor wheels to the other end of the
heater using the same method as shown.
•
After fitting the castor wheels, turn the
heater back over and stand on the wheels.
•
Wait at least 10 minutes for the oil in the
fins to settle down to the bottom before
switching on.
Bottom of Heater
Page 11 of 20