Taylor Made Environmental SMX Series Operation Manual - Slaving Systems
❖
❖
❖
❖
❖
English
17
SMX Online Net Only
Slaving Systems
The SMX Online Net permits multiple air conditioning systems
to be “slaved” together, so that all of them are operated from a
single master control. This is often desirable when more than
one air conditioning unit is installed in a single spacious cabin,
such as a main salon.
It is not necessary for the “slave” unit to have a separate
control panel. In that case, there will be only one control panel
in the cabin. The installer will have programmed the system so
that the slave unit is controlled by the master control panel. If a
separate “slave” control panel is installed, it will work just like
the “master” control panel.
The slave receives operating commands from the master
control unit and cycles on and off according to master’s
setpoint and inside temperature sensor. Fan speeds also
operate in tandem, although you can operate the manual fan
speed of the slave when the master is off.
Slaving From The Slave Control Panel
To slave one unit to another, using the slave’s control
panel:
• Enter the programming mode:
Press OFF.
Press SET.
• Press OFF and SET simultaneously.
• Use the UP or DOWN key to scroll to the ID of the unit that
will be the master.
• Press OFF to save the master ID selection and exit the
programming mode.
Slaving From The Master Control Panel
To slave one unit to another, using the master's control
panel:
• Press SLOW, FAST and FAN simultaneously.
• Use the UP and DOWN key to scroll the ID number of the unit
to be slaved to the master.
• Press SLOW, FAST and FAN again simultaneously. A flashing
decimal will appear in the center of the display to indicate you
are in the remote control mode.
• Enter the programming mode:
Press OFF and SET simultaneously
• Use the UP or DOWN key to scroll to the ID number of the
master.
• Press OFF to save the master ID selection and exit the
programming mode.
• Press COOL, OFF, and HEAT simultaneously to return to
local control mode.
Unslaving Systems From The Master
Control Panel
To unslave systems from master control panel:
• Press SLOW, FAST and FAN simultaneously.
• Use the UP or DOWN key to scroll to the ID number of the
slaved unit.
• Press SLOW, FAST and FAN again simultaneously. A
flashing decimal will appear in the center of the display to
indicate you are in the remote control mode.
• Enter the programming mode.
Press OFF.
Press SET.
• Press OFF and SET simultaneously.
• Use the UP or DOWN key to scroll to the null sign
(--).
• Press OFF to exit the programming mode.
• Press COOL, OFF and HEAT simultaneously to return to local
control mode.