Taylor Made Environmental SMX Series Operation Manual - Network Operation
❖
❖
❖
❖
❖
English
8
A network consists of several SMX Online Net units connected
in a serial chain as shown below. Each SMX Online Net unit is
assigned a controller ID code, which serves as its unique
"address" on the network.
You can perform network functions from any SMX Online
Net control panel on the network, or from the convenience
panel.
A convenience panel is not necessary for network operation.
However, the convenience panel offers single-key control over
certain functions and allows operation of multiple units with a
single keystroke.
Controller ID Numbers
Normally, ID numbers are assigned when the system is
installed, and you will not need to change them. To make it
easier, you can use one of the two-letter codes for spaces such
as the Main Salon (SL) or Forward Stateroom (FS), or you can
use numbers.
To view or change the controller ID for a specific
station:
• Enter the programming mode:
Press OFF
Press SET.
• Press DOWN and OFF simultaneously. The null sign
(--) will appear in the data display if no ID has been assigned.
If an ID has already been assigned to that unit, the current ID
selection will be shown.
• Use the UP or DOWN key to scroll through the possible
SMX Online Net Only
Network Operation
selections until you see the one that you wish to assign to that
station. Note that if you scroll to the end of the list, you will
have to reverse direction to get back to the starting point.
• Press OFF to select the controller ID and exit the program-
ming mode.
• Repeat the above steps at each SMX Online unit in the
network.
CONTROLLER ID CODES:
--
Null (no ID assigned)
PS
Port Stateroom
SL
Salon
SS
Starboard Stateroom
LL
Galley
S1
Stateroom #1
Fb
Flying Bridge
S2
Stateroom #2
PH
Pilot House
S3
Stateroom #3
FS
Forward Stateroom
12-28 Additional cabins
AS
After Stateroom
Note
Make sure you keep a written record of all ID numbers. A
convenient form is provided in the back of this manual. We
suggest that you make a copy of this list and store it separately
in case the manual is misplaced.
Note
In order for the network to function properly, every unit must
have a unique ID. If two of the units are programmed with the
same controller ID, you will have to change one of them.
SMX Online Network
Main Salon
Forward Stateroom
After Stateroom
CONTROLLER ID: SL
CONTROLLER
ID: FS
Shielded 3-Conductor Cable
CONTROLLER
ID: AS
"Master"
Galley
Shielded
4-Conductor
Cable
CONTROLLER
ID: LL
MASTER ID: SL
"Slave"
2nd Unit Slaved
To Master
Shielded
4-Conductor
Cable
Shielded
4-Conductor
Cable
Shielded
4-Conductor
Cable