TDK-Lambda Z+ series User manual - page 8
7
CHAPTER 4: PROGRAMMING COMMANDS
Communication over the GPIB interface meets IEEE 488.2 standards and is Standard Commands
for Programmable Instrumentation (SCPI) compliant.
4.1 SCPI Protocol
Refer to section 7.10 of Z
+
series User Manual
4.2 SCPI Common Commands
Common commands are used to control instrument status registers, status reporting, synchronization,
data storage, and other common functions.
*CLS
Clear Status command. Clears the entire status structure.
*ESE
Standard Event Status Enable command.
*ESR?
Standard Event Status Register query.
*IDN?
Identification query.
*OPC
Operation Complete command.
*OPC?
Operation Complete query.
*OPT?
Returns a string identifying internal options.
*PSC
Power-On Status Clear (PSC).
*RCL
Restores the Power Supply to a state previously stored in memory.
*RST
Resets the Power Supply to a defined state.
*SAV
The SAV command saves all applied configuration setting.
*SRE
Service Request Enable command.
*STB?
Status Byte query. Returns the contents of the Status Byte Register.
*TRG
Command starts the waveform when the trigger source is set to BUS.
ABORt
Resets the trigger system and places the Power Supply in an IDLE state.
For more information refer to section 7.11 of Z
+
series User Manual.