TDK Mojo User Manual - page 17
7. Press and hold ON/PLAY/PAUSE for 20 seconds until the START button in the upgrader software is enabled. (The unit’s INT
and FM LEDs will also both light.)
8. Click the START button.
• A warning window will appear, stating that the player’s internal memory will be erased.
9. To proceed with the upgrade, click YES.
• When complete, a window will open, confirming that firmware upgrade is complete. Do not disconnect MOJO 1 from your
computer before the confirmation window appears.
Formatting MOJO 1’s Memory
If you’ve loaded files into MOJO 1’s internal memory or onto an optional memory card and experience playback issues, you may
need to reformat MOJO 1’s memory.
To reformat MOJO 1’s memory:
1. Power ON MOJO 1.
2. Using the USB cable, connect MOJO 1 to your PC.
3. Run the MOJO 1 PC Software.
4.. Click the MEMORY button, located in the lower left hand side of the MOJO 1 PC Software screen.
• The Memory Utility window will open.
5. Using the pulldown, select MOJO’s memory (internal or optional card, if inserted) that you want to format.
6. Click START.
• A warning screen will appear.
7. Click OK to start formatting or click CANCEL to abort the process.
• After formatting is complete, COMPLETE will appear in the Memory Utility window.
8. After COMPLETE appears, disconnect MOJO 1 from your PC and close the Memory Utility Window.
• To change to order of stations in the RADIO PRESET ORGANIZER list, click any station and click MOVE UP or MOVE DOWN.
The order in which the stations are listed is the order in which the presets will be programmed on MOJO 1.
• To delete a station from the RADIO PRESET ORGANIZER LIST, click the station and click DELETE.
5. When the RADIO PRESET ORGANIZER LIST reflects the desired station presets, click TRANSFER to transfer the presets to
MOJO 1. Previously saved presets will be erased from MOJO 1.
NOTE : MOJO 1 has 20 programmable radio station presets that can be programmed with this software. An additional 5 can be
programmed with MOJO 1’s controls, as described in the”Using Mojo 1” section.
If a MOJO 1 firmware upgrade becomes available, follow the procedure below to update MOJO 1’s internal firmware
(requires live Internet connection):
1. Run the MOJO 1 PC Software.
2. Click the UPGRADE button, located in the lower right hand side of the MOJO 1 PC Software screen.
• A window will open. Click OK to go to the TDK Web site (www.tdk.com/mojo1support) where you can check to see if a
firmware update is available. If a firmware update is available, it will appear as a link on the TDK Web page.
3. Click the “Download firmware” link, select SAVE in the window that opens, choose the location on your hard drive where you
want to save the file, and click SAVE to save the file to your hard drive.
4. After the download is complete, double click on the downloaded file to start the upgrader software.
5. Load a fresh battery into MOJO 1. Power OFF MOJO 1.
6. Using the USB cable, connect MOJO 1 to your PC.
29
30
TDK.l82.03/MOJO 1 User's Guide 9/3/03 9:37 AM Page 28