Teac PCD400i User Manual - To Use As A Radio:
8
To use as a Radio:
Slide
the AUX / iPod / TUNER / CD switch at the side of the unit to select
TUNER
mode.
Slide
the
FM ST / AM
Band dial at the side of the unit to select either FM or
AM
.
Use
the
TUNING
dial at the unit to scan through radio frequencies.
To adjust the volume – turn the VOLUME dial on the unit.
Warning!
This unit has built-in AM ferrite bar antenna, which provides adequate reception in
most areas. If AM reception is weak, turn the unit to improve reception. If FM
reception is weak, adjust the length and the angle of the FM antenna.
Use with other audio devices:
Slide
the
AUX / iPod / TUNER / CD
switch at the side of the unit to select
AUX
mode.
Plug one end of a 3.5mm audio cable (not included) into the AUX port on the
rear of the PCD400i and connect the other end into your external audio
device’s headphone-out or line-out jack.
Activate your external audio device.
This will allow you to broadcast the external device’s sound through the
PCD400i speakers.
Warning!
The remote will not control devices connected via 3.5mm cable.
To set the clock:
In standby mode press and hold the CLK SET button on the main unit or remote
control and select either 24 hour or 12 hour setting using
buttons (Press
CLK SET
button to save).
The hour display will start flashing, press
buttons to adjust the hour
(Press CLK SET to save).
The minute display will start flashing, press
buttons to adjust the minutes
(Press CLK SET to finish all clock setting)