Teac PCD400i User Manual - Battery Operation
9
Battery Operation
Before installing batteries (not included), ensure that the unit
is disconnected from the mains supply.
Remove the battery compartment cover on the back of the
unit by carefully pushing back the battery cover. The battery
cover can then be lifted away.
Fit 8 x 1 .5V C-size batteries (not included), referring to the
polarity markings inside the battery compartment. Never mix
old and new batteries. Finally, replace the cover. For battery
operation, switch off the mains supply and remove the cable
from the power socket, battery operation will be selected
automatically.
CAUTION!
Danger of explosion if batteries are incorrectly replaced. Replace only with the
equivalent type. If you are not going to use your unit for an extended period,
please remove the batteries to avoid damage.
Remote Control Operation
You must remove the spacer before using the remote for the
first time. To remove the spacer, pull off the small tab that is
extending outside the battery compartment as shown.
The main functions of this system can be operated by
pressing the controls on the front panel of the main unit, or by
pressing the corresponding buttons on the remote control.
You should point the remote control at the remote sensor on the front panel. The
effective operating range of the remote control is approximately 10 - 15 feet.
Please note that bright sunlight can interfere with the operation of the remote
control. If the remote operation is unsatisfactory, try darkening the room before
changing the remote battery. The battery should last at least 12 months or longer
under normal operating conditions.
Changing the Lithium Battery
When the operation of the remote becomes intermittent
or the main unit no longer responds to the remote
commands, it is probably time to change the remote
battery.
Open the battery compartment by squeezing the battery
compartment-locking tab as shown and slide the battery
holder out of the battery compartment.
Remove the exhausted battery and install a fresh
CR2025
battery in the battery holder with the “ + ” facing
up as shown, then slide the battery holder back into the
battery compartment.
1
2