THE-ONE TH-103 User Manual - page 10
LED MOVING HEAD LIGHT USER MAUAL
THE-ONE OPTRONICS CO.,LIMITED
9
www.theonelights.com
Connections :
DMX-512 CONTROL CONNECTIONS
1) Connect the male connector of the DMX cable to the female connector(output) on the controller
2) Connect the female connector of the DMX cable to the first fixture’s male connector(input). Note: It
doesn’t matter which fixture address is the first one connected. We recommend connecting the fixtures
in terms of their proximity to the controller, rather than connecting the lowest fixture number first, and so
on.
3) Connect other fixtures in the chain from output to input as above. Place a DMX terminator on the output
to input of the final fixture
to ensure best
communication
FIXTURE LINKING (Master/Slave mode)
1) Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the
first fixture.
2) Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to
the input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect
from the output as stated above to the input of the following fixture and so on.