THE-ONE TH-103 User Manual - page 5
LED MOVING HEAD LIGHT USER MAUAL
THE-ONE OPTRONICS CO.,LIMITED
4
www.theonelights.com
OPERATIONS
1. In the main window ,in turn press “ESC” button
,select DMX mode、auto mode or sound mode,
In DMX mode
: press “UP” “DOWN”to select DMX address;
In Auto mode
:press “UP”“DOWN”to select the device to be a Master or Slave
In sound mode
:press“UP”“DOWN”to select the device to be a Master or Slave
1.1 setting up DMX address
In the main window, press“ENTER” into main menu
,press“UP” or“DWON”selection“1.DMX Address”,and then press“ENTER”into
parameter set
,then press“UP”or“DOWN”to can be set DMX address parameter,then press“ENTER” to save ,press“ESC”to
surrender.
1.2 setting up device working mode
The device can be working the following three modes of either one: DMX mode, auto mode or sound mode
;
In the main window, press“ENTER”into main menu
,press“UP”or“DWON” to select “2.Work Mode”, then press“ENTER” into
parameter saving
, and then press“UP”or“DOWN”to select working mode, then press“ENTER”can be save setting, press“ESC”to
surrender setting.
1.3 setting up Master/Salve mode
When the unit is AUTO or SOUND mode
,can be setting unit as Master/Salve, as Master, the unit in the Auto at the same tine
will be sent to the other asynchronous data. In Slave
, the unit is not sent the data to others,and do not affect the same line of the
normal work of the other light
,setting as below:
In the main window
, press“ENTER” into main menu,press“UP”or“DWON” to select“3.Master”,then press“ENTER”into
parameter
, then press“UP”or“DOWN” to select Mater/Slave mode,after setting,press“ENTER”to salve setting,press“ESC”to
surrender
。
1.4 setting up PAN run direction
In the main window
,press“ENTER”into main menu,press“UP”or“DWON”to select“4.Pan Invert”,press“ENTER”into parameter
setting
,and then press“UP”or“DOWN”to select PAN forward rotating or inversion,after setting,press“ENTER”to save,
press“ESC”to surrender.
1.5 setting up TILT run direction