1. DL manuals
  2. Thelin
  3. Pellet stove
  4. PARLOUR PELLET E.I.
  5. Owner's Manual

Thelin PARLOUR PELLET E.I. Owner's Manual

Summary of PARLOUR PELLET E.I.

  • Page 1

    Parlour pellet e.I. Pellet heater owner's manual installation and operating instructions safety notice ƒ heater must be properly installed and maintained or a house fire may result. ƒ for your safety, follow the installation instructions. ƒ contact local building officials about restrictions and ins...

  • Page 2

    Parlour pellet e.I. Pellet heater 2 index of contents appendix a, 21 appendix b, 22 battery installation, 12 operation, 12 battery light, 12 chrome polishing, 14 circuit board diagram, 18 clean out tee, 7, 8 cleaning exhaust fan blade, 14 fan guard, 14 fly ash removal, 13 glass, 14 gold-plated parts...

  • Page 3

    Parlour pellet e.I. Pellet heater 3 figures figure 1 - overall dimensions................................................................................................................................ 6 figure 2 ..........................................................................................

  • Page 4

    Parlour pellet e.I. Pellet heater 4 12400 loma rica drive, #5 grass valley, ca 95945 530-273-1976.

  • Page 5

    Parlour pellet e.I. Pellet heater 5 general information installation and repair should be done by a qualified service person. The heater should be inspected before use and at least annually by a professional service person. More frequent cleaning may be required due to fuel quality, excessive lint f...

  • Page 6

    Parlour pellet e.I. Pellet heater 6 figure 1 - overall dimensions figure 2 figure 3 - exhaust pipe location (rear view) clearances check with local building officials for specific code requirements. A listed, type "l" pellet vent pipe is mandatory on all installations. Clearance to combustibles unit...

  • Page 7

    Parlour pellet e.I. Pellet heater 7 figure 4 figure 5 installation 1. When deciding on the location of your heater and vent pipe, try to minimize the alteration and reframing of structural components of the building. Vent pipe must be installed so that access is provided for inspection and cleaning....

  • Page 8

    Parlour pellet e.I. Pellet heater 8 figure 6 figure 7 figure 8 8. The pellet heater must be operated with a power source and will not operate using natural draft. If there is a power failure the heater will shut down. If the 12-volt back-up system is installed, the heater will automatically switch t...

  • Page 9

    Parlour pellet e.I. Pellet heater 9 b. All pellet vent pipe connections including exit at the rear of the heater should be sealed with high temperature silicone (450 degrees) or metallic duct tape. This prevents smoke and soot leakage into the living area. If this is not done, there is a possibility...

  • Page 10

    Parlour pellet e.I. Pellet heater 10 figure 10 fire pot must be fully seated in opening before loading with pellet fuel. No gaps should be visible around edges. See "start-up and operation" for lighting instructions. Figure 11 start-up and operation a. Filling the hopper and start-up caution: fuel h...

  • Page 11

    Parlour pellet e.I. Pellet heater 11 if you choose to use a wall or remote thermostat follow the thermostat manufacturers instructions carefully and make sure you use the built in thermostat terminals on the bottom of the stove. (see figure 9) we recommend you run the heater on “high” for about 30 m...

  • Page 12

    Parlour pellet e.I. Pellet heater 12 battery light: when the green light is blinking the battery is charging. When the green light is steady the battery is fully charged. If this light is red, then the battery terminals are plugged in backward. Trim button: on the left side of the control panel ther...

  • Page 13

    Parlour pellet e.I. Pellet heater 13 maintenance procedures caution: moving parts may cause injury. Do not operate with rear cover removed. Warning: risk of electrical shock. Disconnect all power before servicing. Always turn your heater off and let it cool before cleaning. Figure 13 your parlour pe...

  • Page 14

    Parlour pellet e.I. Pellet heater 14 1. Hopper clean out: vacuum the accumulated saw dust in the hopper weekly. Keep free of debris and foreign material. An accumulation of saw dust can cause irregular pellet feed. For best results this should be done on a regular basis depending on how often the he...

  • Page 15

    Parlour pellet e.I. Pellet heater 15 remove any foreign material or object and restart the heater. Caution: keep fingers and hands clear of the feed mechanism when heater is on. 3. Problem: the fire was burning well and then it began to overfeed pellets and started backing up into the pellet feed ch...

  • Page 16

    Parlour pellet e.I. Pellet heater 16 solution: fan motor brushes are wearing out. Brushes in fan motor need to be replaced. Contact your dealer or call factory for replacement brushes. 9. Problem: stove shuts off at night when running on low. Solution: feed is to low. Adjust feed trim button (turn c...

  • Page 17

    Parlour pellet e.I. Pellet heater 17 12 figure 14 item part no. Description 1 43100-11 door glass 2 43100-13 fiber door gasket 3 43000-10 control knob 4 43000-04 control switch 5 43000-02d fuel feed disk 6 43000-02c fuel feed auger 7 43000-02 fuel feed motor 8 43000-03 control circuit board 9 43000-...

  • Page 18

    Parlour pellet e.I. Pellet heater 18 figure 15 - circuit board diagram gnome type 2 parlour type 1 17.0

  • Page 19

    Parlour pellet e.I. Pellet heater 19 figure 16 - electrical schematic/wiring diagram.

  • Page 20

    Parlour pellet e.I. Pellet heater 20 figure 17 – routine stove clean out and maintenance the following is a step-by-step procedure to clean out and maintain your pellet stove. 1. Stove must be shut off and completely cold before performing this maintenance. 2. Open door; remove fire pot and clean-ou...

  • Page 21

    Parlour pellet e.I. Pellet heater 21 appendix a – wind warning additional venting problems occasionally, the vent configuration can create a noisy, harmonic condition that will make a noise similar to the one made by blowing over a bullet shell or beer bottle. This sound can be eliminated by closing...

  • Page 22

    Parlour pellet e.I. Pellet heater 22 appendix b – e.I. Firepot assembly.

  • Page 23

    Parlour pellet e.I. Pellet heater 23 thelin company pellet heater warranty replacement program effective april 1, 1995 note: please read this warranty replacement program carefully before applying for warranty replacements or credit. Warranty coverage warranted for five years from the date of retail...

  • Page 24

    Parlour pellet e.I. Pellet heater 12400 loma rica drive, #5 grass valley, ca 95945 530-273-1976.