Thelin PARLOUR PELLET E.I. Owner's Manual - page 9
PARLOUR PELLET E.I.
PELLET HEATER
9
b. All pellet vent pipe connections including
exit at the rear of the heater should be sealed
with high temperature silicone (450 degrees)
or metallic duct tape. This prevents smoke
and soot leakage into the living area. If this
is not done, there is a possibility that the
room fan will pick up any leakage and blow
it into the room.
c. Installation per Figure 8 requires 4” pellet pipe.
WALL & REMOTE THERMOSTAT
INSTALLATION FOR PARLOUR E.I.
A wall or remote thermostat can be hooked to run
the Parlour 3000 E.I. automatically. The following
is a step-by-step procedure for installing the optional
thermostat. Note connection terminals on the bottom
right side of the unit (see Figure 9). Use 18/2 thermostat
wire for installation.
1. Unplug heater from the wall outlet!
2. Hook up the thermostat wires to terminals (see
Figure 9). Remember to remove copper shunt.
Replace shunt if thermostat hook-up is
disconnected. If a remote thermostat is used you
will have to mount the “receiver” to the bottom
of the stove with Velcro and then hook up
receiver wires to the terminal (see Figure 9).
Follow thermostat manufacturer’s instructions.
3. Locate thermostat approximately 10 to 12 feet
from heater or in an area that requires steady
temperature. Run thermostat wires from heater
to thermostat along wall or under carpet, etc.,
and hook wires to thermostat terminals. For the
remote find a central location that will maintain
room temperature and leave remote in that area.
4. Make sure all wiring is complete before
plugging the Parlour back into the wall outlet.
IMPORTANT: Any electrical work performed on
the Parlour should be done by qualified personnel.
Always plug AC cord in before DC battery.
FIGURE 9
Fuse Holder: To remove fuse, push cap in
and turn counter-clockwise
Rotated and enlarged view of plate